Main Content

Wireless Testbench

Test wideband wireless systems and perform spectrum monitoring

Wireless Testbench™ enables you to test wideband wireless systems and perform spectrum monitoring with high-speed data capture using MATLAB® with USRP™ N3xx, X3xx, or X4xx.

You can set waveform-specific characteristics in hardware to trigger the capture of data of interest for post-processing and analysis in MATLAB. You can use hardware-based resampling to transmit and capture custom signals at arbitrary sample rates or standards-based signals (5G and WLAN) at their native sample rates. You can also integrate custom IP blocks with RF Network-on-Chip (RFNoC™) into the signal processing chain on the USRP FPGA (with HDL Coder™).

Get Started

Learn the basics of Wireless Testbench

Radio Management

Connect and set up SDR hardware

Transmit and Capture

Transmit and capture IQ data over the air for use in simulation, testing, and validation

Spectrum Monitoring

Capture and analyze IQ data from the air using preamble or energy detection

Live Data I/O

Transmit and receive IQ data over the air with live processing

Target NI USRP Radios

Prototype and test SDR algorithms on NI™ USRP radio hardware

Wireless Testbench Supported Hardware

Support for third-party hardware