photo

Anush


Last seen: 7ヶ月 前 |  2023 年からアクティブ

Followers: 0   Following: 0

統計

  • Knowledgeable Level 1
  • First Answer

バッジを表示

Feeds

表示方法

回答済み
issue with displaying the changing values on scope block via MATLAB function block
Hello Mehreen, If you are experiencing issues with displaying the changing values of the temperature in a Simulink model while ...

1年以上 前 | 0

回答済み
Cannot run and debug Simulink model on some LAUNCHXL-F28379D boards
Hello Shreyas, The above issue may be because of several reasons including port access permissions and physical connection issu...

1年以上 前 | 0

回答済み
How can I interface my Texas Instrument DSP with available CAN communication through simulink
Hello Ashik, One effective approach to interface your TIF28379D board with CAN protocol through simulink is to make use of the ...

1年以上 前 | 0

回答済み
How to read I2C from chip that does not use traditional registers but commands
Hello Johannes, You can make use of the AD5272 Datasheet to come up with a suitable workflow for the read operation. The data...

1年以上 前 | 0

| 採用済み

回答済み
STM Nucleo real-time in external mode or connected IO
Hi Daniil, You can do real-time parameter tuning and logging using external mode with STM32 F103RB nucleo board. You need to i...

1年以上 前 | 0

回答済み
how to convert .mat file to .nrrd file with correct size
Hello, Instead of the following line of code: img = load('outVol.mat'); You need to access the outVol field of the img struct...

1年以上 前 | 0

| 採用済み

回答済み
How do I compute the p-value of the highest r-value from the function [c,lags]=xcorr(A,B)?
Hello Sammy, To compute the p-value of the highest correlation value obtained from the xcorr() function, you can do the followi...

1年以上 前 | 1

回答済み
Saving an arabic string into a .txt file makes it all distorted
Hello Charbel, For the fwrite() function, make the following change: fwrite(fileID, stego, 'char', 'n'); This specifies that ...

1年以上 前 | 0

回答済み
Top left cell in uitable
Hi Abhishek, There doesn't seem to be a direct way to achieve it. However, you can make use of 'Labels' to do the task. Followi...

1年以上 前 | 0

回答済み
STM32 code generation
Hi Vasu, The problem actually exists in the configuration in STM32CubeMX and not in the target link file. Enable the 'Do not g...

1年以上 前 | 0