photo

Nikhil


Last seen: 1年以上 前 |  2023 年からアクティブ

Followers: 0   Following: 0

I am a fourth year undergraduate student at IIT Madras, in the department of Engineering Design.

Programming Languages:
Python, C
Spoken Languages:
English, Hindi, Telugu
Pronouns:
He/him
Professional Interests:
Control Systems, Automotive

統計

  • Knowledgeable Level 2
  • First Answer

バッジを表示

Feeds

表示方法

回答済み
Simulink Constant Ramp Controller
Yes, It helps. You can derive the transfer function for the controller since you know the transfer function for the system and t...

1年以上 前 | 0

回答済み
One of my system that I want to control with the controller has 3 input variables as it has a disturbing vector. How can I design with matlab simulink?
Refer to this article for information on designing MIMO State Space systems : MIMO State Space Models

1年以上 前 | 0

回答済み
How do I address issue with width and dimension of PI i simulink
The error occurs because PLL block accepts only one sinusoidal signal as input. To use it for the case of three phase Voltages/C...

1年以上 前 | 0

| 採用済み

回答済み
using Hindsight experience replay (HER) in Matlab 2021a
No, It is not possible to use the HER syntax in a version older than 2023a, since it was introduced in 2023a.

1年以上 前 | 0

| 採用済み

回答済み
My ideal rotational speed sensor and ideal torque sensors are not working at the same time
Kindly check this link where a similar question has been answered. Additionally refer to this example model on how to connect ...

1年以上 前 | 0

回答済み
For the control subsystem of the Four-Switch Buck-Boost Converter, may I know what are the functions of vRef, v, FF, and Reset?
In the DC-DC Voltage Converter block, vRef is the Desired DC ouput voltage v is the measured DC output voltage FF is the fe...

1年以上 前 | 0

回答済み
How do I create a controller to stabilize an inverted pendulum in Simulink?
You can refer to this article Control of an Inverted Pendulum on a Cart which discusses how to design a PD controller for an inv...

1年以上 前 | 0

| 採用済み

回答済み
Simulink - Powertrain Engine Fuel in mg/injg --> kg/s
It is my understanding that you are confused about whether to input the fuel mass flow rate in kg/s or mg/inj. You should import...

1年以上 前 | 0