How do I address issue with width and dimension of PI i simulink

I am working on validating a model for my project, the simulink built and return two (2) errors similar to each other as written below

=== Simulation (Elapsed: 6 sec) ===

Error:Error in port widths or dimensions. 'Output Port 1' of 'Emma/PLL/Model/Continuous PID/Kp6' has 3 elements. This port does not accept the dimensions (or orientation) specified by the output signal.

Error:Error in port widths or dimensions. Invalid dimension has been specified for 'Input Port 1' of 'Emma/PLL/Model/Continuous PID/Transfer Fcn'.

[Nikhil]

Can you share the model to reproduce the issue?

[Manasseh Shitta]

@Nikhil See the model as requested for kind assistance

Answer 1

[Nikhil]

The error occurs because PLL block accepts only one sinusoidal signal as input. To use it for the case of three phase Voltages/Currents, you can use a PLL (3ph) block.

Refer to this documentation, for more information on the PLL block. Also, look into the example attached in the article, which showcases the use of PLL and PLL(3ph) blocks.

Additionally refer to this article for information on PLL(3ph) block.

[Manasseh Shitta]

I appreciate it Nikhil, I would try it out and give you feedback. Thank you