zedboard fpga in loop

9 ビュー (過去 30 日間)
irem
irem 2015 年 8 月 20 日
コメント済み: Eduardo Flores 2020 年 11 月 29 日
Hello, Has anybody used zedboard in fpga in loop simulation? If so are there any documents or explainitions? Thank you

回答 (2 件)

Tao Jia
Tao Jia 2015 年 8 月 24 日
Note that zedboard only supports JTAG connection with the host when using FPGA-in-the-Loop, while this tutorial was designed for both Ethernet and JTAG connection. You just need to following the instructions specific to Xilinx JTAG.
To run this demo, you need Xilinx Vivado.
  4 件のコメント
irem
irem 2015 年 9 月 7 日
I have tried however I have the error # current_hw_device [lindex [get_hw_devices] $chain_position] # refresh_hw_device -update_hw_probes false [lindex [get_hw_devices] $chain_position] # set_property PROGRAM.FILE {C:\Users\Student\Documents\MATLAB\R2015a_start\DUT_fil\DUT_fil.bit} [lindex [get_hw_devices] $chain_position] # program_hw_devices [lindex [get_hw_devices] $chain_position] ERROR: [Labtoolstcl 44-10] Device arm_dap_0 is not programmable What can be the problem? Best regards
Eduardo Flores
Eduardo Flores 2020 年 11 月 29 日
Hey @Irem, did you managed to solve the Device arm_dap_0 is not programmable error?

サインインしてコメントする。


Antti Wredfors
Antti Wredfors 2015 年 9 月 23 日
I have some diffuculties with new 2015b release too. It's a litle bit same like previous post. The tcl file will not download bitstream correctly.
HDL Workflow advisor can sometimes program Zedboard, but usually it does not! If I use Vivado 2014.4 to download bitstream then it works. (Without tcl functions)
What I discovered was that "vivado_download.tcl"-file is not fully correct at this Vivado 2014.4 release. With Simulink 2015a and Vivado 2014.2 this works always correctly. But not anymore with new releases.
Original vivado_download.tcl file uses command "current_hw_target [get_hw_targets *]". If I remove this line from tcl file, then this works perfectly.
Is there any soutions for bitstream download issues?
BR Antti
  2 件のコメント
Ram Bhaskara
Ram Bhaskara 2020 年 3 月 28 日
Hi! I did not understand how to get around this error. Can you please suggest the steps to get around it?
labtoolstcl 44-10 device arm_dap_0 is not programmable
Thanks!
- Ram
Eduardo Flores
Eduardo Flores 2020 年 11 月 29 日
Did you solve this isse @Ram Bhaskara? I have the same problem

サインインしてコメントする。

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by