Feeds
回答済み
ZedBoard support package in a different module
The carrier board is needed to boot from sd card. TE0720 will work, but there are different models. Try to choose most similar o...
ZedBoard support package in a different module
The carrier board is needed to boot from sd card. TE0720 will work, but there are different models. Try to choose most similar o...
7年以上 前 | 0
回答済み
ZedBoard support package in a different module
It will need some work, but it is possible. If the io is exactly same then it's quite easy to get running. Some work is needed i...
ZedBoard support package in a different module
It will need some work, but it is possible. If the io is exactly same then it's quite easy to get running. Some work is needed i...
7年以上 前 | 0
質問
How to convert system.string to uint8?
I'm using .NET to read FTDI usb uart serial data. The following method: str = System.String('create a System.String...
約8年 前 | 0 件の回答 | 1
0
回答質問
ZedBoard support package in a different module
Hello, I'm using now a Zedboard and it's support package. I would like to run hardware in the loop in a different platform, w...
9年以上 前 | 2 件の回答 | 0
2
回答質問
Worflow advisor tcl scripts generates error at programming phase
Hello, Advisor section "4.4 Program Target Device" will pick any device with xilinx or digilent interface and will cause prog...
約10年 前 | 2 件の回答 | 0
2
回答回答済み
zedboard fpga in loop
I have some diffuculties with new 2015b release too. It's a litle bit same like previous post. The tcl file will not download bi...
zedboard fpga in loop
I have some diffuculties with new 2015b release too. It's a litle bit same like previous post. The tcl file will not download bi...
10年以上 前 | 1
質問
HDL Workflow advisor co-simulation to custom board, freerunning mode
Is there some way how to get custom Zynq board to freerunning mode with co-simulation? I do have now ZedBoard which runs co-si...
10年以上 前 | 1 件の回答 | 0
