Merge 3D matrices into one cell array without using a loop

1 回表示 (過去 30 日間)
mashtine
mashtine 2015 年 6 月 24 日
編集済み: Stephen23 2015 年 6 月 25 日
I have three 3D matrices (mxnxt) that I would like to merge into a single array of mxn with each array holding the corresponding data from the original matrices. Thus {1,1} of the new array will have a tx3 matrix containing the data.
For instance, A, B and C are 10x10x300 matrices. How do I make D to be a 10x10 array where {1,1} is a 300x3 matrix, without using a loop, but simple vector indexing.
Hope this makes sense!

採用された回答

Stephen23
Stephen23 2015 年 6 月 24 日
編集済み: Stephen23 2015 年 6 月 24 日
Try this:
A = rand(10,10,300);
B = rand(10,10,300);
C = rand(10,10,300);
D = permute(cat(4,A,B,C),[3,4,1,2]); % join together, re-orient
V = ones(1,10);
D = squeeze(mat2cell(D,300,3,V,V)); % split into cell
And the output:
>> size(D)
ans =
10 10
>> size(D{1,1})
ans =
300 3
  4 件のコメント
mashtine
mashtine 2015 年 6 月 25 日
Thanks Stephen,
I wish it were so simple however. I was very large files (a few GB each) with netcdf data that I need to do calculations on that aren't so straight forward. Hardware is the biggest issue and thus my splitting of arrays. My computer simply cannot handle one large array, that when all the data is stored in, will be approximately over 25 GB. I cannot even load that into my workspace. Unless again, I am missing something. Steep learning curves!
Stephen23
Stephen23 2015 年 6 月 25 日
編集済み: Stephen23 2015 年 6 月 25 日
There are basically three ways of dealing with Big Data:
  1. Change the algorithm so that it is not necessary to hold all of the data in memory.
  2. Use tools designed to operate on Big Data.
  3. Buy lots more memory.
Do an [internet search engine] search for "MATLAB Big Data" and you will find lots of discussions on these topics. Well, mostly on the first two, but the third gets mentioned too!

サインインしてコメントする。

その他の回答 (1 件)

Matt J
Matt J 2015 年 6 月 25 日
編集済み: Matt J 2015 年 6 月 25 日
There is no way to do it without for-loops. Note that mat2cell and friends are all mfiles that use loops internally.
The data organization you are pursuing is ill-advised. Instead of cell arrays, you should just cat() them into a 4D numeric array
D=cat(4,A,B,C);
Now to access a tx3 sub-array, you can do things like
squeeze(D(i,j,:,:))
It would have been much better and cleaner if you had instead made the original arrays tx1xmxn. That way, you could concatenate as
cat(2,A,B,C)
and your sub-arrays would be in more efficient memory-contiguous blocks and also more simply indexed as D(:,:,i,j). You can use permute() to achieve this, of course, but permute() is an expensive operation.

カテゴリ

Help Center および File ExchangeCreating and Concatenating Matrices についてさらに検索

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by