フィルターのクリア

Is there any method in simulink to Connect with Zynq ultrascale + MPSoC ZCU104 FPGA Board.

2 ビュー (過去 30 日間)
ATHUL
ATHUL 2024 年 7 月 19 日
編集済み: Kiran Kintali 2024 年 7 月 19 日
I am involved in a project to design and hardware model the CNN Alexnet architecture in Simulink for object detection.My target FPGA Board is Xilinx Zynq Ultrascale MpSOC ZCU104. But it is not shown in HDL Workflow analyzer . Is it possible to generate the verilog code only for my CNN Architecture in simulink without specifying the board details and then manually uploading code to xilinx vivado or are there any possibilities to Connect to the target board Xilinx Zynq Ultrascale MPSoC ZCU104

回答 (1 件)

Kiran Kintali
Kiran Kintali 2024 年 7 月 19 日
編集済み: Kiran Kintali 2024 年 7 月 19 日
You can use this custom reference design steps to register your ZCU104 board for use with DL HDL workflow. Following the above steps would make the board appear in the workflow advisor as supported option.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by