Connection Failed in hardware setup
1 回表示 (過去 30 日間)
古いコメントを表示
I need to use HDL Coder and Embedded Coder for my Zynq board. I did install the following hardware support packages.
- HDL coder for Xilinx Zynq
- Embedded coder for Xilinx Zynq
- Simulink Coder
- Matlab coder
After installing, try to do the hardware setup.
It writes the image into the SD card but while verifying I am getting connection failed message and i am not able to test the netwrok connection.
I did the hardware setup with the following scenarios also,
- Using Ethernet USB 3.0 dongle
- Connecting both host PC and Zynq board via Router
- Connecting Both Host PC and Zynq board via common LAN
- Given Static IP address to the Zynq board used
But still getting the same error, Activation connection Failed.
I am using UBUNTU 18.04 version and I need to do the network connection in the same.
Thanks in Advance.
2 件のコメント
Dr. W. Kurt Dobson
2023 年 2 月 12 日
I'm having the same problem with a Xilinx ZedBoard. It passes the Host IP address configuration and the host-hardware connection, but fails on 'Test hardware memory transaction'.
I can open the ZedBoard on FireFox using the ZedBoard IP address, and it shows the two directories of the image that was written on the SD Card.
Using: Operating System: Linux 5.15.0-58-generic #64~20.04.1-Ubuntu
Emna Aridhi
2023 年 5 月 22 日
Please How could you connect to the zedboard via ethernet and display its terminal?
回答 (1 件)
参考
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!