Erman Korkut

MathWorks

2011 年からアクティブ

Followers: 0   Following: 0

メッセージ

統計

  • Knowledgeable Level 2
  • First Answer

バッジを表示

Feeds

表示方法

回答済み
Why is uncertainty parameter outside input-output loop not linearised in robust control toolbox?
Hi J. Van, This is the expected behavior. When the uncertainty is not in the linearization path given the input and output lo...

10年以上 前 | 0

| 採用済み

回答済み
Model Reference Blocks and systune
Hi Jim, I would recommend to make sure that the blocks you specify to be tuned (and all their parent models all the way to th...

11年弱 前 | 0

回答済み
How does source affect Simulink's frequency response estimation?
Hi Lauri, This is a common issue frequency response estimation users encounter. Simulink Control Design offers ways to find a...

11年以上 前 | 1

回答済み
Control Design: Linearization at multiple operating points simultaneously
Another alternative would be to use "Linearize At..." menu item in Operating Point drop down (2nd from the top, below "Model Ini...

12年弱 前 | 0

回答済み
how to copy LTI viewer figure to clipboard?
Hi Noam, This is an excellent suggestion, currently it is not possible to do it inside the linear analysis tool. But as a wor...

約13年 前 | 1

| 採用済み

回答済み
Integers in control loops
Hi Mark, How are you rounding your controller output? If you are using the quantizer block, there is a checkbox for "treat ga...

13年以上 前 | 1

| 採用済み

回答済み
Linearization gives accurate results with Simulink Control Design but not with linmod
The underlying reason can be a lot of things for the difference: # If you have more than one input/output points, the channels ...

13年以上 前 | 0

回答済み
(Simulink/MPC) Unable to linearize with an if...else loop
Hi Tan, The Embedded MATLAB function blocks are linearized using numerical perturbation by default. Your code seems to indica...

13年以上 前 | 1

回答済み
Computing Operating point using Simulation Snapshots
Hi Tan, To stop the model from trying to initialize from a no longer existent operating point, you can go to the menu in Simu...

13年以上 前 | 1

| 採用済み