photo

Paul

MathWorks

2016 年からアクティブ

Followers: 0   Following: 0

メッセージ

統計

All
  • Knowledgeable Level 2
  • First Answer
  • Solver

バッジを表示

Feeds

表示方法

回答済み
How to control GPIO of ARM on Zedboard
There currently is no support for GPIOs on a Zedboard from the ARM. LEDs and DIP switches are connected to the FPGA, you can ...

5年以上 前 | 0

回答済み
Chang center frequency quickly
* It is possible to change the CenterFrequency property while the System object is locked as it is a tunable property. Give a l...

5年以上 前 | 0

回答済み
The received signal from sdrrx keeps unchanged even if I connect or disconnect the loopback cable to trainsmitter port TxA and receiver port RxA
Hi Ardeal, There is enough leakage between the unconnected RF connectors to lead to the results you are seeing on the example...

5年以上 前 | 0

| 採用済み

回答済み
Run transmitter and receiver model in 1 model or 2 separate model in parallel
Hi Ardeal, The answer I gave to your other post should cover this question too. <https://uk.mathworks.com/matlabcentral/answe...

5年以上 前 | 0

| 採用済み

回答済み
Question about how to run TX and RX calibration example model on zedboard with zynq
Hi Ardeal, Transmit and receive on one same hardware using Tx and Rx blocks is not recommended. As both documentation link yo...

5年以上 前 | 0

| 採用済み

回答済み
Zynq Radio Software Interface Model: UDP send/receive blocks not working
Thanks for the details Harry. About the loopback cable: you will have enough leakage from the unconnected antennas for them t...

6年弱 前 | 1

回答済み
Zynq Radio Software Interface Model: UDP send/receive blocks not working
Hi Harry, The setup details you are providing are correct. The Ethernet port you are currently using will be fine if it is th...

6年弱 前 | 1

| 採用済み

解決済み


Times 2 - START HERE
Try out this test problem first. Given the variable x as your input, multiply it by two and put the result in y. Examples:...

8年弱 前