photo

Surojit Sen


2016 年からアクティブ

Followers: 0   Following: 0

統計

  • Thankful Level 1

バッジを表示

Feeds

表示方法

質問


Freewheeling diode causing error in Full-Bridge Inverter model
Hi, please see the attached Simulink model. Its a simple full-bridge inverter producing quasi-square alternating voltage at the ...

約7年 前 | 0 件の回答 | 0

0

回答

質問


How to dynamically change a block parameter value during simulation run-time?
I have been trying to find an easy way of doing this, but have failed till now. The problem is like this: I want to implement a ...

7年以上 前 | 1 件の回答 | 0

1

回答

質問


What Simulink tool should I use to break a continuous signal into its frequency components?
I have a continuous signal which is composed of multiple frequency components, not necessarily harmonics. How do I separate this...

7年以上 前 | 1 件の回答 | 0

1

回答

質問


'Degenerate Mass on Follower Side' issues?
[Please refer to the screenshots, as the portal does not allow attaching Simulink (.slx) models here] *** EDIT MADE TO QUESTION:...

7年以上 前 | 0 件の回答 | 0

0

回答

回答済み
Can a joint produce 'Sensing' outputs resolved in the follower frame?
Got the answer after a bit of scouring the library, simply use a 'Transform Sensor' in parallel to the joint, and output whateve...

7年以上 前 | 0

質問


Can a joint produce 'Sensing' outputs resolved in the follower frame?
Take for example the planar joint, can I get the position, velocity, acceleration of the follower frame resolved in the follower...

7年以上 前 | 1 件の回答 | 0

1

回答

質問


Pacejka Tire Model (Magic Formula) for lateral dynamics?
The Magic Formula block in Driveline is excellent, but only caters to the longitudinal forces/acceleration of the tire. I unders...

7年以上 前 | 2 件の回答 | 0

2

回答

質問


How do I set block parameter value using a Mask property?
I want to convert a Suspension block subset into a generic suspension Mask. This mask would have a few popups. A particular bloc...

7年以上 前 | 1 件の回答 | 0

1

回答