S POORNIMA

Last seen: 4ヶ月前 | 2016 年からアクティブ

Followers: 0 Following: 0

統計

ランク
71,668
of 298,292

評判
0

コントリビューション
8 質問
1 回答

回答採用率
0.0%

獲得投票数
0

バッジを表示

Feeds

質問

rms plot of voltage sag during faults
I want to get rms plot for a fault voltage like this using simulink. kindly help.

約4年前 | 0 件の回答 | 0

0

回答

質問

iam trying to simulate a nonlinear transformer of simscape. iam getting a mismatch error in current and flux vector. but i have verified it many times . please help me to sort this
iam trying to simulate a nonlinear transformer of simscape. iam getting a mismatch error in current and flux vector. but i have...

7年弱前 | 0 件の回答 | 0

0

回答

回答済み
I am trying to simulate a voltage transformer in simulink. Iam getting a spike voltage at the beginning of the secondary voltage (rated 110V but getting 6000V). how to prevent this
Sir, I have attached the model. if i enable hysteresis, Instead of 6000v spike iam getting 50v normal sine waveform. if i disabl...

7年弱前 | 0

質問

I want to simulate a n channel JFET(UJN1208K) in simulink. but Iam not getting its small signal parameters from the datasheet. can you please help to give the simulation procedure
I want to simulate a n channel JFET(UJN1208K) in simulink. but Iam not getting its small signal parameters from the datasheet. c...

7年弱前 | 0 件の回答 | 0

0

回答

質問

I am trying to simulate a voltage transformer in simulink. Iam getting a spike voltage at the beginning of the secondary voltage (rated 110V but getting 6000V). how to prevent this
I am trying to simulate a voltage transformer in simulink. Iam getting a spike voltage at the beginning of the secondary voltage...

7年弱前 | 1 件の回答 | 0

1

回答

質問

Current vector, i and Magnetic flux vector, phi must be of the same size In elec.passive.nonlinear_transformer
I WANT TO SIMULATE A VOLTAGE TRANSFORMER OF 50VA, 11KV/110V. WHEN I ENTER THE CURRENT ANS MAGNETIC FLUX VECTOR, the error says t...

7年以上前 | 0 件の回答 | 0

0

回答

質問

How to interface Pspice and Matlab simulink? How to get SLPS software to interface? If not by SLPS software, what else can be used to interface?
How to interface Pspice and Matlab simulink? How to get SLPS software to interface? Is there any specific website to download t...

8年弱前 | 0 件の回答 | 0

0

回答

質問

How to get memristor block to be used in simulink? If i get is it possible to use in Matlab2013R version?
I want to use memristor emulator circuit in my models. How to get memristor emulator block to be used in simulink? If i get is i...

8年弱前 | 0 件の回答 | 0

0

回答

質問

How to plot Poincare map and Bifurcation diagrams of ferrosonance
I doing research in Ferroresonance. Please help me to learn to plot Poincare map and Bifurcation diagrams of ferrosonance.

9年弱前 | 1 件の回答 | 0

1

回答