Ahmed Desoky

Last seen: 10ヶ月前 | 2016 年からアクティブ

Followers: 0 Following: 0

ランク
22,733
of 298,292

評判
2

コントリビューション
7 質問
1 回答

回答採用率
0.0%

獲得投票数
2

質問

How do I perform PID controller from error by using matlab script?
I want to change the PID that is shown in this figure to matlab script I am tring to use PID=Kp*ev + Ki * integral(ev)+ Kd ...

5年以上前 | 0 件の回答 | 0

回答

回答済み
Error while importing the excel file into signal builder
I have the same problem on 2016a. did you get a solution?

約8年前 | 0

質問

How to select some element from matrix by simulink?
I want to get all element except -1 By Simulink For example: u2 = [46.15 ; -22.5 ; -1 ; ...

約9年前 | 0 件の回答 | 0

回答

質問

How to find the index of the first non-zero element in a 2-D array in simulink?
I want to find the index of the first non-zero element in a 2-D array in simulink, just like the way that 'find' command in ...

約9年前 | 0 件の回答 | 1

回答

質問

How to save video and images from usb webcam in Raspberry Pi by simulink?
I had connected the usb webcam to Raspberry Pi. I loaded the Simulink model that mention below onto Raspberry Pi board from the...

約9年前 | 0 件の回答 | 1

回答

質問

How to execute the Simulink model from Raspberry Pi?
I have built a Simulink model consisting of three blocks (Pulse generator + Data Type Conversion + GPIO Write) to flash a LED. ...

約9年前 | 0 件の回答 | 0

回答

質問

How to start Simulink model on Raspberry Pi automatically on startup?
I have built a Simulink model consisting of three blocks (Pulse generator + Data Type Conversion + GPIO Write) to flash a LED. ...

約9年前 | 1 件の回答 | 0

回答

質問

How to do Simulink model run in Raspberry Pi after power on (booting) as standalone ?
I build a Simulink model to control Dc motor, load into the board, stop Simulink model and plug out the power and Ethernet cable...

約9年前 | 0 件の回答 | 0

回答