Community Profile

photo

SAnbaran


Last seen: 1年以上 前 |  2018 年からアクティブ

Followers: 0   Following: 0

統計

  • First Review

バッジを表示

Feeds

表示方法

回答済み
missing data in target object
SOLVED. To those who read this in future. I used 'outport block' to log data and solve this problem by increasing 'Signal logg...

4年以上 前 | 0

| 採用済み

質問


missing data in target object
Hi everyone, I ran an ICE-based car model in real-time and desktop. But the real-time figure obtained from target object has so...

4年以上 前 | 1 件の回答 | 0

1

回答

回答済み
how to tune PID controller for a vehicle model in Simscape?
I did it and it works fine. here https://www.mathworks.com/matlabcentral/answers/467606-why-i-can-t-tune-design-pid-for-a-vehicl...

4年以上 前 | 0

回答済み
Error when doing Real-Time Simulink in External Mode "Unable to create mex function"
I managed to solve this problem. The cause of this error was the missing headers in C compiler, 'stddef.h' . I use Microsoft V...

4年以上 前 | 1

質問


Error when doing Real-Time Simulink in External Mode "Unable to create mex function"
Dear Sir/Madame, I am trying to do Real-Time simulatation of a vehicle model that is built in simscape. I have already d...

4年以上 前 | 2 件の回答 | 0

2

回答

質問


Why I can't tune/design PID for a vehicle modelled with simscape?
Hi all, the model is a conventional car with multi-speed transmissoin. It is build using simscape and the control objective is...

5年弱 前 | 1 件の回答 | 1

1

回答

質問


How did steve Miller Tune several PI controllers in his full HEV Model?
Greetings, I would, deparately and enthusiastically,like to learn how Mr.Miller tuned PIs in his HEV model? I am working on ...

5年以上 前 | 0 件の回答 | 0

0

回答

質問


receiving error when try to Linearize a single Simscape block (e.g. Engine) from a Simscape Model.
Greetings, I would like to model a Simscape model. The model is an Engine-based powertrain with ICE+Torque converter+ CVT+Vehi...

5年以上 前 | 0 件の回答 | 0

0

回答

質問


Is it possible to use dSPACE 1104 and MATLAB to do HIL?
Hello, Can I use dSPACE 1104 and MATLAB to set-up HIL? Thanks, Sajad

6年弱 前 | 1 件の回答 | 0

1

回答

質問


How to find steady-state Operating point for a vehicle model built using Simscape?
What I essentially try to do is to control ICE speed with a PI controller. the model is attached to this message. Below is th...

6年弱 前 | 1 件の回答 | 0

1

回答

質問


how to tune PID controller for a vehicle model in Simscape?
Hello,Would you please tell me how to tune PID controller for a vehicle model built in Simscape? I watched several of MATLAB...

約6年 前 | 2 件の回答 | 0

2

回答