Community Profile

photo

Raghunath Rachabattuni

Last seen: Today |  2022 年からアクティブ

連絡

統計

  • Knowledgeable Level 1
  • First Answer

バッジを表示

Content Feed

表示方法

回答済み
Kindly tell me if the code (MTPA) is wrong for calculating MTPA curve
You can use the commandline utilities that are shipped with Motor Control Blockset. Please refer to the following links to explo...

7ヶ月 前 | 0

回答済み
Challenges with Delta Wound Motor in Torque Control: Seeking Guidance on MTPA Reference Block for reference Id and Iq generation.
Hi Aditya, In addition, check the following link for using delta parameters for a motor plant model. One of the options (the...

7ヶ月 前 | 0

回答済み
to obtain contour plots
You can use the commandline utilities that are shipped with Motor Control Blockset. Please refer to the following links to explo...

10ヶ月 前 | 0

回答済み
Using Ld and Lq inductance values for IPMSM
Additionally, you may also use the Ld Lq and fluxPM values using the blocks MTPA Control Reference and LUT based PMSM Control Re...

10ヶ月 前 | 0

| 採用済み

回答済み
about the contour plots
To plot the constant torque contours and also other constraint curves of a PMSM, please refer to the following link. PMSM Cons...

10ヶ月 前 | 0

回答済み
How to draw MTPA curve on torque contours
To know how to draw the MTPA curves, and also other constraint curves of the PMSM, pls refere to the following link. PMSM Cons...

10ヶ月 前 | 0

回答済み
To calculate the max speed which can be achieved in field weakening region
A recent update to the Motor Control Blockset introduced few utilities to address these. PMSM Drive Characteristics and Constr...

10ヶ月 前 | 0

回答済み
can you provide me a file about flux weakening model of PMSM in simulink ?
In addition to the above suggested block, you may also use MTPA Control Reference or LUT based PMSM Control Reference blocks. To...

10ヶ月 前 | 0

回答済み
Field-Weakening Control (with MTPA) of PMSM
Hi You can refer to the following link to know the the principles behind the MTPA curve of a PMSM, and find how to plot them. ...

10ヶ月 前 | 0

回答済み
LUT based PMSM control reference ; Vdc input method
To add to the above answer, the 3D LUT option creates a 3D table for both id, iq values that depend on three parameters, namely,...

10ヶ月 前 | 1

| 採用済み

回答済み
Torque control of PMSM motor- Need help
Hi, The torque setpoint can be derived using the PI controller based on the speed setpoint and the speed feddback value. You ma...

1年以上 前 | 0