photo

Shengnan Li


Franklin Electric

Last seen: 1年以上 前 |  2016 年からアクティブ

Followers: 0   Following: 0

メッセージ

統計

  • First Review
  • Thankful Level 1

バッジを表示

Feeds

表示方法

質問


Can someone provide a peak current mode controlled buck or boost circuit model in simulink?
Does anyone have a peak current mode controlled buck or boost or other power circuit model?Save me some time. Thanks a lot.

約3年 前 | 0 件の回答 | 0

0

回答

質問


how to control Ball valve input signal s
The ball valve model has an input signal s to control ball displacement. I don't understand how it is controlled. for example, i...

7年以上 前 | 1 件の回答 | 0

1

回答

質問


signal input of orifice/valve
How to specify this input? Thanks,

8年弱 前 | 0 件の回答 | 0

0

回答

質問


Why signal changes rise/fall time outside the subsystem block?
I have a subsystem that has a direct look up table in it. the output of this look up table is the upper one in the attached fig....

約8年 前 | 0 件の回答 | 0

0

回答

回答済み
'to workspace' data length question
Thanks for answering my question. I finally figured out, it is the 'decimation' parameter. It was set to 5. when i changed to 1,...

約8年 前 | 0

| 採用済み

質問


'to workspace' data length question
I specified the sample time for 'to workspace' block to be 10^(-5), but it saved only 20k data points, while it should be 100k d...

約8年 前 | 2 件の回答 | 0

2

回答

質問


how to get the average frequency for the hysteresis band control?
I am simulating a Direct torque control induction motor. Want to know the average frequency. How do i get it from the switching...

約8年 前 | 1 件の回答 | 0

1

回答

質問


Why I get different data from 'to workspace' and 'scope'
I have a switching signal, and a 'edge detector', try to count the pulses. The results from scope looks very good, the 'edge det...

約8年 前 | 1 件の回答 | 0

1

回答