統計
All
Feeds
質問
R2013a 64 Bit + Stateflow + Simulink + MinGW + Gnumex = working?
Hi, I wonder if I can use the combination of mentioned programs under Windows 7 64Bit? Does Stateflow work? I have serious...
12年以上 前 | 0 件の回答 | 0
0
回答回答済み
Closed kinematic system assembly error (SimMechanics Second Generation)
I had the same problem and solved it by looking concentrated at the coordinate systems for hours. Then I changed a single digit ...
Closed kinematic system assembly error (SimMechanics Second Generation)
I had the same problem and solved it by looking concentrated at the coordinate systems for hours. Then I changed a single digit ...
12年以上 前 | 0
質問
Measure reaction forces in joints and bearings
Hi! I built a model in SimMechnics 2G. It seems to work quite good :) Is there a way to measure the reaction forces or the...
12年以上 前 | 1 件の回答 | 0
1
回答回答済み
How to connect with breadboard and matlab
you could get an arduino or raspberry pi, a dc-power-source (12v-battery for example), some mosfet-circuitry and a sensor to mea...
How to connect with breadboard and matlab
you could get an arduino or raspberry pi, a dc-power-source (12v-battery for example), some mosfet-circuitry and a sensor to mea...
12年以上 前 | 1
| 採用済み
解決済み
Make the vector [1 2 3 4 5 6 7 8 9 10]
In MATLAB, you create a vector by enclosing the elements in square brackets like so: x = [1 2 3 4] Commas are optional, s...
12年以上 前
解決済み
Times 2 - START HERE
Try out this test problem first. Given the variable x as your input, multiply it by two and put the result in y. Examples:...
12年以上 前
質問
More information about assembly (or why is something not assembling)
Hi, I wonder if there are more tools in SimMechanics 2G than the Explorer who simply states: Joint x ist bad. For example, so...
12年以上 前 | 1 件の回答 | 0
1
回答質問
How to interface Stateflow charts with Bus signals
Hi, In my model a stateflow chart has a lot of inputs and outputs. Is it possible to feed a bus signal directly into or ou...
12年以上 前 | 2 件の回答 | 0
