Oliver McEnteggart

2012 年からアクティブ

Followers: 0 Following: 0

メッセージ

Professional Interests: Control theory

統計

バッジを表示

Feeds

質問

Running sequential simulations in a simulink model
I have a simulink model with a set of about 10 parameters. I also have a set of about 15 different sets of parameters, I am tryi...

13年以上前 | 1 件の回答 | 2

1

回答

回答済み
Output first zero of a signal?
Thanks for that help, I have another related question though how would I go about finding the time difference between each succe...

13年以上前 | 0

質問

Output first zero of a signal?
Is there anyway to output the first time at which a signal is zero (excluding at t = 0)?

13年以上前 | 3 件の回答 | 0

3

回答

質問

How to I output the maximum value of a signal to a display?
Is there anyway to output the maximum value of a signal that varies with time in simulink to a display block?

13年以上前 | 1 件の回答 | 0

1

回答

質問

How to route a signal without routing it through every layer in a simulink model
Is there anyway to route or find the value of a signal that is in a reference model several subsystems below the outer level dir...

13年以上前 | 1 件の回答 | 0

1

回答

質問

Extracting a response time in simulink
So I have a control system in simulink which I have put into a test harness and I want to find the response time for that system...

13年以上前 | 1 件の回答 | 0

1

回答

質問

Error: Cannot propogate bus signal from output 1 to input 5
I keep getting this error when I try to run a simulation with a model reference. The signal is created by a subsystem which then...

13年以上前 | 1 件の回答 | 1

1

回答

質問

Nested buses in base workspace
I'm trying to define a nested bus structure in the base workspace of MatLab. However, I'm not sure how I should actually write t...

13年以上前 | 1 件の回答 | 1

1

回答

質問

Test harnesses and reference models
Hi, I am making a test harness in simulink to test an actuator model and have ran into a problem. The actuator itself is a re...

13年以上前 | 1 件の回答 | 0

1

回答