photo

Chethan Pandarinath


Stanford University

Last seen: 2年以上 前 |  2012 年からアクティブ

Followers: 0   Following: 0

メッセージ

See http://npl.stanford.edu/~chethan/

統計

All
  • Personal Best Downloads Level 1
  • First Review
  • 5-Star Galaxy Level 1
  • First Submission
  • Revival Level 1
  • First Answer

バッジを表示

Feeds

表示方法

回答済み
Return not working when debugging?
I found this same issue when I recently upgraded to 2016a. While 'return' during debugging would resume execution in older versi...

8年以上 前 | 2

質問


xPC Target & concurrent models - how to get TET?
I have an xPC target model that runs on 4 separate cores. I would like to get the task execution time (TET) for all the cores. ...

10年以上 前 | 1 件の回答 | 0

1

回答

回答済み
xPC Target error: ERROR: EtherInit: EtherID 1: Binning Error 776
It turns out this issue was solved by increasing the Network Buffer sizes under the Buffer Mngmt blocks. The model ran without i...

10年以上 前 | 0

| 採用済み

質問


xPC Target error: ERROR: EtherInit: EtherID 1: Binning Error 776
I'm getting the error listed above when trying to execute an xPC model. The same model runs fine if I remove one of the Ethernet...

10年以上 前 | 1 件の回答 | 0

1

回答

回答済み
Issue with building reference models with xPC target
Just for everyone's future reference, the solution to this problem was achieved in the following way: In Model Configuration ...

10年以上 前 | 0

| 採用済み

回答済み
error using text()
Just wanted to confirm that I see this issue in MATLAB R2012b: text() fails if either of the passed in x- or y-position argument...

11年弱 前 | 0

回答済み
Using xPC Target, how do I configure multiple NICs for real-time UDP?
I just wanted to mention that I've seen this same error (EtherID X: Registration Error 2) when I accidentally had two Network Co...

11年弱 前 | 0

質問


Issue with building reference models with xPC target
I have a model that requires concurrent execution (multiple processors) to run effectively. This means that the top-level model ...

11年弱 前 | 2 件の回答 | 0

2

回答