photo

Nandhini


Last seen: 5ヶ月 前 |  2023 年からアクティブ

Followers: 0   Following: 0

統計

  • Thankful Level 2
  • Explorer

バッジを表示

Feeds

表示方法

質問


Edit poles and zeros in root locus design editor or bode editor
While i am trying to get the bode plot for my input and output from my simulink model i am getting the error as mentioned below ...

6ヶ月 前 | 1 件の回答 | 0

1

回答

質問


Scaling of generated duty cycle from simulink to NXP MCU expresso environment
I have developed the FOC model for PMSM, the generated code has been integrated with driver code in NXP MCU expresso environment...

10ヶ月 前 | 1 件の回答 | 0

1

回答

質問


Angle estimation from hall sensor using hall decoder block
While i am trying to find the angle from hall sensor signal using hall validity block and hall decoder block, the angle varies o...

11ヶ月 前 | 1 件の回答 | 0

1

回答

質問


Error: Integrating the generating code from embedded coder in renesas cubesuite(CS+) environment
Hi, I developed the FOC alogorithm in simulink environment and i generated the embedded code for renesas rl 78, when iam trying...

約1年 前 | 1 件の回答 | 0

1

回答

質問


Issue when running the motor from open loop host model - Used custom hardware (Open-Loop Control and ADC Offset Calibration)
Open-Loop Control and ADC Offset Calibration using this link i generated the code from the model for STM32 Nucleo F302R8 bull ru...

約1年 前 | 0 件の回答 | 0

0

回答

回答済み
Code generation from Simulink to STM32F103 Processor.
Hi,thank you for the support.I tried implementing the open loop model, i generated the code and also integrated it with driver c...

約1年 前 | 0

質問


Code generation from Simulink to STM32F103 Processor.
I developed a model in simulink for BLDC motor with trapezoidal commutation with PI based speed and current control,I want to co...

約1年 前 | 2 件の回答 | 0

2

回答

質問


If else condition is not working properly in matlab function block
function [y1,y2]= fcn(u1,u2,u3,u4) if u1 > 5 y1=u2; else y1=u3; end if u1 < 5 y2=u3; else y2=u2; end I implem...

約1年 前 | 1 件の回答 | 0

1

回答