photo

tq yu


Last seen: 約2年 前 |  2019 年からアクティブ

Followers: 0   Following: 0

統計

  • First Answer
  • Revival Level 1
  • Thankful Level 1

バッジを表示

Feeds

表示方法

回答済み
how can i send datas(rea-time ,get from udp communication) from the workspace to simulink while the simulation is on?
Has been solved ,thanks

約5年 前 | 0

| 採用済み

質問


how can i send datas(rea-time ,get from udp communication) from the workspace to simulink while the simulation is on?
hi ,everybody there I want to send sensors datas in the matlab workspace derieved from udp communication to simulink model ,to...

5年以上 前 | 1 件の回答 | 0

1

回答

回答済み
How to use real time input from workspace in Simulink
hi ,there ,have you solved the problem?I just encounter the similar issue .Below is the similar QS by onther ,wish to help you. ...

5年以上 前 | 0

回答済み
why the sensing output of the joint block(vel,acce,torque) is all zeros? I set the motion in actuator : provided by input(from workspace) and the torque:automatilcally computed .The manipulata move as expected .
have a look at the similar situation: https://ww2.mathworks.cn/matlabcentral/answers/377250-why-is-measured-joint-velocity-zero...

5年以上 前 | 0

| 採用済み

質問


why the sensing output of the joint block(vel,acce,torque) is all zeros? I set the motion in actuator : provided by input(from workspace) and the torque:automatilcally computed .The manipulata move as expected .
As above . The sensing position is presicely the same as input joints angles from workspace ,but the sensing vel,acce and the t...

5年以上 前 | 1 件の回答 | 0

1

回答

質問


after import robot from urdf ,how can i sent angles to the joints ,and test my own kinermatic algorithm?
I have a problem and need help. I want to use 'smimport' by simscape or 'importrobor' by robotics robotics system toolbox from ...

5年以上 前 | 1 件の回答 | 0

1

回答