photo

Arne


Invivo Diagnostic Imaging

Last seen: 3年以上 前 |  2014 年からアクティブ

Followers: 0   Following: 0

メッセージ

Professional Interests: Signal Processing

統計

All
  • First Review
  • Thankful Level 1
  • Solver

バッジを表示

Feeds

表示方法

質問


HDL NCO: How do I set the fraction length for the phase accumulator?
Hello, I want to design a high precision NCO, but I want to keep the LUT short. For example, I want to use a 16bit LUT but wan...

6年以上 前 | 1 件の回答 | 0

1

回答

回答済み
MiniZed Support Package for Simulink and Matlab 2018a - how to setup SDK?
Hi Noam, Yes, and I finally seem to got it working. There seems to be a bug when setting when setting up the SDK for Embedded ...

7年弱 前 | 0

質問


MiniZed Support Package for Simulink and Matlab 2018a - how to setup SDK?
Hello, I installed the Linux sytem for the Matlab/Simuling HW/SW codesign on my Minized. I went through the installation a...

7年弱 前 | 2 件の回答 | 0

2

回答

質問


How can I read RGB values with the EV3 Color Sensor block for Simulink?
I am trying to convert the Mindstorms Rubik's cube solver from NXT to EV3. However, the EV3 color sensor block let's me only re...

8年以上 前 | 0 件の回答 | 0

0

回答

解決済み


Find the sum of all the numbers of the input vector
Find the sum of all the numbers of the input vector x. Examples: Input x = [1 2 3 5] Output y is 11 Input x ...

8年以上 前

解決済み


Make the vector [1 2 3 4 5 6 7 8 9 10]
In MATLAB, you create a vector by enclosing the elements in square brackets like so: x = [1 2 3 4] Commas are optional, s...

8年以上 前

解決済み


Times 2 - START HERE
Try out this test problem first. Given the variable x as your input, multiply it by two and put the result in y. Examples:...

8年以上 前

質問


Fixed-Point Designer tells me that "Magnitude-Angle to Complex" Block is not supported. Why?
Hi, I am trying to convert a Simulink model that contains several "Magnitude-Angle to Complex" blocks to HDL code. When runni...

9年以上 前 | 1 件の回答 | 0

1

回答

質問


Problems with HDL Coder, 64QAM and Zedboard
I am trying to run the 64QAM HDL Coder example "commqamtxrxhdl" on a Zedboard and the HDL Workflow Advisor gives me the followin...

10年以上 前 | 0 件の回答 | 0

0

回答

回答済み
Problems with RTL-SDR and Simulink
Ken, Thanks for your answer. I managed to resolve my problem: The USB driver for the RTL-SDR was installed incorrectly. ...

11年弱 前 | 1

質問


Problems with RTL-SDR and Simulink
I recently installed RTL-SDR under Simulink. While the support package works fine on one of my computers, I keep on getting err...

11年弱 前 | 2 件の回答 | 0

2

回答