Community Profile

photo

Nick Van Oosterwyck


University of Antwerp

Last seen: 約1ヶ月 前 |  2021 年からアクティブ

Followers: 0   Following: 0

I am a PhD researcher at the University of Antwerp, currently working on the development of a CAD-enabled a priori and online trajectory optimisation for repetitive movements, advised by professors Stijn Derammelaere and Annie Cuyt. While in grad school I discovered I am fascinated by robots and mechatronics, especially those used in an automated production environment. From this interest, I try to conduct further research into more efficient and performant systems. I also enjoy teaching and guiding theses.

統計

All
  • Personal Best Downloads Level 1
  • First Submission
  • Knowledgeable Level 1
  • First Answer
  • Solver

バッジを表示

Feeds

表示方法

回答済み
Tolerances are relative or not in interior-point for fmincon?
You can also get an overview of all the algorithms and whether the tolerances are relative or absolute on: https://www.mathwork...

約1年 前 | 0

送信済み


hemisphere
Create hemisphere

約1年 前 | ダウンロード 5 件 |

Thumbnail

送信済み


hemicylinder
Generates cylinder with hemispherical ends.

約1年 前 | ダウンロード 1 件 |

Thumbnail

回答済み
Incorrect logarithmic axes after setting 'defaultAxesNextPlot' to 'add'.
When you enable hold on with set(groot,'defaultAxesNextPlot','add'), the figure and axes properties become locked. Thus, because...

2年弱 前 | 1

| 採用済み

解決済み


Times 2 - START HERE
Try out this test problem first. Given the variable x as your input, multiply it by two and put the result in y. Examples:...

2年以上 前