Chao-Hwa Chen

Last seen: 5ヶ月前 | 2019 年からアクティブ

Followers: 0 Following: 0

統計

Feeds

回答済み
Replicate the Event-Driven Task in External Mode
To fix the connect error, I followed this link (https://www.mathworks.com/matlabcentral/answers/103456-why-do-i-get-a-failed-to-...

約1年前 | 0

回答済み
Failed to Connect to Hardware when Building and Loading for External Mode
I found a fix for the hardware connection error, verified in both R2023b and R2024a. On the "SYSTEM ON CHIP" tab, click "Hardw...

約1年前 | 1

| 採用済み

質問

Replicate the Event-Driven Task in External Mode
I am trying to replicate the simulation results of the event-driven task in external mode. I ran in R2022a. My board is Zedboard...

約1年前 | 2 件の回答 | 0

2

回答

質問

Failed to Connect to Hardware when Building and Loading for External Mode
While trying to run the example of event-driven task ( https://www.mathworks.com/help/soc/ug/event-driven-task-example.html ) in...

約1年前 | 1 件の回答 | 0

1

回答

質問

Run UDP as Simulator for OFDM TX/RX
I tried to run the Simulate portion of https://www.mathworks.com/help/soc/ug/OFDMTransmitandReceiveUsingXilinxRFSoCDevice.html ...

1年以上前 | 1 件の回答 | 0

1

回答

質問

Upsampling and then Downsampling Causing Sample Read Issues
I have a Simulink model trying to push the data payload into the TX buffer by using 4 16-bit TXDMA ports and IIO buffer push and...

3年弱前 | 1 件の回答 | 0

1

回答

回答済み
R2020b Update 6 Crashes After Opening HDL Workflow Advisor
After idling for 2 days and then removing both slprj and hdl_prj folders, it started working again. It is fine now.

約4年前 | 0

| 採用済み

質問

R2020b Update 6 Crashes After Opening HDL Workflow Advisor
After updating MATLAB R2020b Update 6, when I opened the HDL Workflow Advisor, MATLAB always crashes. Even if I uninstall and th...

約4年前 | 3 件の回答 | 0

3

回答

回答済み
Why do I receive an assertion in portmgr.cpp:340:Error: Invalid port index 13 requested when 12 is the max port index for comp
I found the problem. It is that I put the upsampling before the HDL block and then the downsampling within the HDL block. That c...

約6年前 | 0

質問

Why do I receive an assertion in portmgr.cpp:340:Error: Invalid port index 13 requested when 12 is the max port index for comp
When I try to generate HDL code for my model in R2019a, I receive an assertion error below. How do I resolve this error? Assert...

約6年前 | 3 件の回答 | 0

3

回答

質問

Two Errors Happen When Running R2019a Instead of R2018a on ADI RF SOM Board
I have run the tones project successfully in MATLAB R2018a. I try to run the same thing in R2019a. I replaced the ADI RF SOM ARM...

約6年前 | 1 件の回答 | 0

1

回答