Why do I receive the error "system execution can not be started" while using xPC Target?

I have a host PC and a target PC with SCRAMNET board. I ran XPCTEST and that was successful. After that, I opened my model and tried to build it. However, the process failed with the following error message on the target PC screen:

 System: download started...

 System: download finished

 System: initializing application...

 Error:  Scramnet+ SC150(bus 0,slot 4): board not provided

 System: execution cannot be started

Answer 1

[MathWorks Support Team]

From the error message, it is appearent that the Scramnet Board is not placed in bus 0 and slot 4. To resolve the error, place the Scramnet Board in bus 0 and slot number 4.

Alternatively, you can identify the slot in which the board is located and accordingly modify the information in the driver block corresponding to SCRAMNET board inside the Simulink model.

To identify the bus and the slot number in which the board is located, execute the following command on the MATLAB prompt:

getxpcpci('all')

From the output information, identify the bus and slot in which the Scramnet Board is placed. Then, enter that bus number and the PCI slot number using the format [BusNumber, SlotNumber] in the dialog parameter "PCI slot" of the driver block corresponding to SCRAMNET board.