Hardware tools and blocks

Hello 

I would like to inquire about the implementation model that I built with Matlab on the hardware side. I did it with normal PWM and it works by connecting each pulse to the GPIO block.

So here as in picure, I need to implement it by using SPWM (Sinwave and comparing it with sawtooth). Which block should I use in hardware like (GPIOx or ePWM) and is there a private block that I should use instead of that used with normal PWM and simulation?

If anyone could please guide me, send me a hardware model or send a video to understand this issue,

These are the pulses that I want to send to my circuit and this picture includes the GPIO block from hardware tools. 

Thanks in advance. 

[SALAH alatai]

up

[LO]

Hi Salah, which kind of hardware would you like to interface with MATLAB and for what purpose ? It is not clear at all what your issue is, at least not to me :)

[SALAH alatai]

Hi LO I want to implement a circuit Multilevel Inverter. Normal Hardware by using F2879D launchpad Microcontroller to get signal on ociliscope.

[SALAH alatai]

HELLO

[SALAH alatai]

up

[SALAH alatai]

up