How to know the frequency of the signal from fft

1 回表示 (過去 30 日間)
632541 2021 年 6 月 13 日
コメント済み: dpb 2021 年 6 月 13 日
How do i know the frequency of the signal from fft ?
First graph is signal and second is fft of the same .
Piece of code for fft is here.
%%z is the signal
nfft=length(z); %Number of samples
FTSignal=2*fft(z)/nfft; %FFT of the signal y-axis
FTSignal=FTSignal(1:nfft/2); %FFT till for nyquist frequency
%take magniutde
AbsFFT=abs(FTSignal);
f=(0:(nfft/2)-1)*fs/nfft; %Frequency range x-axis
phase=angle(FTSignal); %Phase spectru
figure(4)
plot(f,AbsFFT);
title('FFT of signal')
xlabel('Frequency in Hz')
ylabel('Amplitude');
Any changes in the code or in my understanding of fft (or frequency ) ?
3 件のコメント1 件の古いコメントを表示1 件の古いコメントを非表示
632541 2021 年 6 月 13 日

Thanks dpb.
fs=50000; %%Sampling frequency
This is the result after subtracting z by mean of z.
z=z-mean(z);
dpb 2021 年 6 月 13 日
Well, your plot is the right range, then, but we also don't know what numel(signal) is so we can't tell what the frequency resolution would be.
If you look at your signal, you have (barely) one cycle of a sine wave with a distended second half-cycle and just a tiny wiggle in it. There is little frequency content there to be found; rightfully you should have a time sample some 3-4X as long to have a long enough sample to see the frequency content over at least 3-4 cycles of the lowest frequency of interest.
If there is anything else in the weeds, try converting the output amplitude to dB or just turn the y axis to logarithmic (alto then zeros will disappear). On the linear scale, there simply isn't enough dynamic range to see anything except the rolloff near the DC component which what I'd expect the output to reflect given the input.

サインインしてコメントする。

カテゴリ

Help Center および File ExchangeFourier Analysis and Filtering についてさらに検索

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by