Simulink scope issue with data not showing

3 ビュー (過去 30 日間)
SALAH alatai
SALAH alatai 2021 年 5 月 25 日
回答済み: Pavan Guntha 2021 年 8 月 31 日
hello
I am trying to sens some pulses to the microcontroller F28379D, system is ok buliding and show the pulses on Oscilloscope, I put some scope blocks to show the signal on simulink MATLAB but the scopes did not show anything.

回答 (1 件)

Pavan Guntha
Pavan Guntha 2021 年 8 月 31 日
Hello Salah,
You could try unchecking 'Limit data points to last' option in the configuration parameters of the Scope block since it stores only the last 5000 data points (as per the attached figure). For more details you could have a look at the following documentation page: Specify signal values to log
Hope this helps!

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by