Can't connect to USRP N321(or N310)
古いコメントを表示
I setup the N321 follow the step ,but it prompts that the N321 cannot be found, and I have ruled out many situations and have not solved it. Can you give me some suggestions? And how should I ensure that the host can connect to N321.

回答 (1 件)
Karunya Choppara
2021 年 6 月 14 日
0 投票
Hi
Please follow the Recommended action and click on "Assign IP Address" button, and you should be able to see the detection result successful, once the IP address is set as per the recommended action.
7 件のコメント
Anton Dobler
2021 年 6 月 29 日
I have the same problem... No success using your approach. Firewall is down for the specific interface and pinging works fine...
I appreciate any help!
Thank you!
Anton Dobler
2021 年 6 月 29 日
By the way: I am using two USRPs N310 with XG FPGA image, allowing two 10Gigabit Ethernet NICs...
uhd_config_info --version says I am on UHD 3.15.0.0-0-gaea0e2de
Karunya Choppara
2021 年 7 月 6 日
Have you changed the default IP addresses of the SFP 0 port? The Hardware Setup App works for default IP address of 192.168.10.2 for SFP port 0
What happens after you click on "Assign IP Address" button on the Hardware Setup App?
Ali Sabra
2022 年 2 月 14 日
In my case the hardware is correctly detected in this step. When I click next, Matlab start checking if the FPGA image is compatible (on the SD card) and this step takes forever. It never finish loading.
Although I am sure that the FPGA image on the SD card is compatible. When I run findsdru, I get no device found. Although two days ago everything was fine, I could use the N310 with Matlab with no issues. I did not change anything so I really don't understand why today Matlab is not detecting the N310. I can still ping the device but not more. Matlab does not see it although the FPGA image is 100% compatible.
Does anyone know what is the problem ??
Karunya Choppara
2022 年 2 月 18 日
Hi Ali,
Have you tried restarting the N310? and then try findsdru
MIKEL GUTIERREZ NAVARRO
2023 年 2 月 28 日
Dear all, I am having the same problem and despite following the steps of "Assign IP Address" I still have the same error. I'm working with an N310 on Windows 10 with UHD_4.1.0.4
Mikel
Karunya Choppara
2023 年 3 月 9 日
Hi Mikel
Can you try the manual configuration by following the steps under the section " Configure Ethernet Connection Via Windows Network Connections App "
カテゴリ
ヘルプ センター および File Exchange で Communications Toolbox についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!