Simulation does not complete 100% compilation

My simulink simulation doesnt compile upto 100% i domnt know why. Tried changing step time , stop time and sampling size.

[Pratheek Punchathody]

Can you explain a bit more about the use case or incase of any error that is occuring ? This would help the community to get more understanding on the issue.

[shalaka sitre]

so i made one simulation of a multidrive system and used the power gui and logged all the scopes.

Then i went ahead and created a single unit system consisting of three phase power source , rectifoer inverter and load. the powergui doesnt seem to record the inputs from the scope. all the scopes are shown from my previous file which i already closed.

i dont knw why.