![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1672996/0c8c6b778f2c55a9ce3f992b30b8e4d4.png)
How to enable the signal visualization blocks in the "QPSK Receiver with ADALM-PLUTO Radio" example?
2 ビュー (過去 30 日間)
古いコメントを表示
MathWorks Support Team
2020 年 12 月 15 日
編集済み: MathWorks Support Team
2024 年 4 月 18 日
I am trying to use the signal visualization blocks found in the following example (QPSK Receiver with ADALM-PLUTO Radio):
However, I can not find a way to activate these signal visualization blocks as the process to do so is not mentioned in the example documentation.
I had noticed that one sentence in the doc says, "To ensure real-time processing, the model is by default set to run in Accelerator mode, and to remove all signal visualization", but when I tried running the model in Normal mode there was no change. How do I activate these blocks?
採用された回答
MathWorks Support Team
2024 年 4 月 18 日
編集済み: MathWorks Support Team
2021 年 12 月 22 日
In the example model, if you double click on the QPSK receiver block, you will see the spectrum analyzer and constellation diagram blocks (4 blocks in total) as shown below.
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1672996/0c8c6b778f2c55a9ce3f992b30b8e4d4.png)
Please right-click on each of these blocks and select 'Uncomment'. Uncommenting all these four blocks should show you the visualizations.
0 件のコメント
その他の回答 (0 件)
参考
カテゴリ
Help Center および File Exchange で RF Component Modeling についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!