Matlab Support package for SensorDAQ and Thermocouple.

3 ビュー (過去 30 日間)
Li 2013 年 2 月 28 日
コメント済み: Francisco Redondo 2014 年 8 月 28 日
Right now I can use NIMAX(provided in NI website for SensorDAQ drivers) to see the thermocouple is actually working. However, when I try to add the sensor in matlab that it will told me the valid channel is ai0,ai1. And I use the following channel in MAX: Channel Name: "Dev1/_sensor0_5V". The error message is the following when I try to run matlab with the Matlab Code:
Error Message:
The device 'Dev1' does not have a channel '_sensor0_5V'. Valid channel IDs are 'ai0, ai1'.
Please help me configure this issue, I believe it's the matlab support package didn't specify the right channels

回答 (1 件)

Rob Purser
Rob Purser 2013 年 12 月 12 日
Are you using the Vernier SensorDAQ with R2012a or later? If so, and you still want to use it, let me know, I may have a workaround for you.
-Rob Purser
  2 件のコメント
claire 2014 年 5 月 7 日
I have almost the same problem, I am using Vernier hand dynamometer and SensorDAQ. When using sdaq.addSensor(session, 1, sdaq.Sensors.HandDynamometer); I have the same error.
When I try to use directly session.addAnalogInputChannel('Dev1', 'ai0', 'Voltage');
I have a code error saying: NI Error -200983: You only can get the specified property while the task is reserved, committed or while the task is running. Reserve, commit or start the task prior to getting the property. Property: DAQmx_SampClk_Rate Task Name: _unnamedTask<2D> Status Code: -200983
Is there any way to fix the error ?
Thank you very much;
Francisco Redondo
Francisco Redondo 2014 年 8 月 28 日
Hello I am using Vernier hand dynamometer and SensorDAQ with MATLAB R2013b.
When I write the code: s = sdaq.createSession; sdaq.addSensor(s,1,sdaq.Sensors.HandDynamometer);
I have the next error.
Could you help me?



Help Center および File ExchangeMATLAB についてさらに検索



Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by