How to break down three phase pulses into single phase for gate pulses?
2 ビュー (過去 30 日間)
古いコメントを表示
I have a gate signal controlled with PWM which is used on the gate of an IGBT converter block. There are six pulses in all. The model which is simulating the connection of a wind turbine to the grid with full size converter works fine. Only problem is I believe the grid side converter block is causing a lot of low frequency harmonics on my output current signal.
To try and eliminate this I want to replace the IBGT converter block with an approximate controlled current source and three controlled voltage sources. I need to use the three gate signals for each phase for maths operations to approximate the converter.
So my question is how can I break the gate pulse signal into 3 seperate pulses, one for each phase? I have tried demux but it isn't working for me. This is probably a real easy fix.
2 件のコメント
Azzi Abdelmalek
2013 年 2 月 7 日
It's not clear what you mean by "break the gate pulse into 3 separate pulses" ?
回答 (1 件)
Joel Van Sickel
2020 年 12 月 11 日
Hello Mark,
sorry for this being too late for you. Use mux and demux blocks to access combined signals. You can also use selector blocks for this.
Regards,
Joel
0 件のコメント
参考
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!