Unable to Build Android test App on Device - Android Version 10 || Matlab & Simuink R2020b

Hello,

This is regarding the Simulink Support Package for Android and I face a configuration issue

I am unable to install the test App in the configuration setting as the Error shows that "No matching files were found".

Android SDK Setup and the Samsung Driver setup and well as the USB debugging mode was successfully installed and configured.

I use Matlab version R2020b and Android Version 10. I am not sure if this question is asked somewhere, but I hope I get answers for the above specified

version. Please share the missing test app files for R2020b if available and also advice where to install and configure those files

Thanks

Answer 1

[Sutanu Maiti]

If you are seeing “No matching files were found.” error in Verify Configuration screen during Hardware Setup for the Android Studio version 4.1 or above, then you may download a lower version of Android Studio from below archives link:

https://developer.android.com/studio/archive

You may choose Android Studio 4.0.2 which was released on October 6, 2020 or any version below that.

During installation you may choose a different folder than the default location if you want to keep your existing Android Studio installation.

Once installation is complete, you may run hardware setup again using this newly installed Android studio and it should go through.

[Raiyan Shaikh]

Thank you very much.

I uninstalled the latest version and installed the version you mentioned at the default drive.

The configuration was successful this time.

[Adrián Estraviz González]

Hello,

I had had the same problem as Raiyan Shaikh expose in this post, and I try to apply the solution that you give him. But a new problem was created, now it displays a new Error that says "Old Version of Gradel detected. Update Android Studio as described in Get Latest Version of Android Studio and run Hardware Setup process again", and that was the cause of the first error.

I am using MATLAB R2019b and Android 10, I download and install drivers and the debugging activate. So if you could please came with a solution a I would be very grateful.

[jesus minguez]

I have the same problem

[Sutanu Maiti]

Can you please install NDK version 22.* only (not 23) and try once? I hope that would work.