Arduino Issue: I cannot run any of my code. 'To create a new connection, clear the existing object.'
20 ビュー (過去 30 日間)
古いコメントを表示
I have only just begun to learn how to work with arduinos in matlab. My code will not run past the third line, so here are the first few lines:
clearvars
clear all
ard_UltraS('COM4', 'Mega2560','Libraries','Ultrasonic') = arduino;
Matlab gives an error at the third line:
"MATLAB connection to Mega2560 at COM4 exists in your workspace. To create a new connection, clear the existing object."
I have tried clear all, clearvars, clearing that specific variable, restarting matlab, restarting my computer, and different USB ports. With each of these attempts i get the same error. Is there anything to clear the variable I haven't tried? or some way to make sure that the arduino is disconnected?
1 件のコメント
Rohan Kale
2020 年 10 月 16 日
Hi William,
The construct of the syntax "ard_UltraS('COM4', 'Mega2560','Libraries','Ultrasonic') = arduino;" is not supported for creating an arduino object.
Please use the following syntax instead:
>> ard_UltraS = arduino('COM4', 'Mega2560','Libraries','Ultrasonic');
or
>> ard_UltraS = arduino;
Hope it helps.
回答 (1 件)
Arun Kumar
2020 年 10 月 16 日
Hi Willian,
Please refer the following page for correct syntax of the command.
Hope this helps!
-Arun
0 件のコメント
参考
カテゴリ
Help Center および File Exchange で MATLAB Support Package for Arduino Hardware についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!