Serial Flush Simulink Android

Hi

Is there a way to Flush the incomming serial data in Simulink?

I am using Simulink Support Packages for Android and trying to receive serial data on android model...

Right now the problem is some times data comming is corrupted, so I want to Flush the stream of data...

If you have another alternate solution that would be great as well...

I am sending 5 unit16 (10 uint8) to android device...Right now some times it works some times no.. that because the data is becomming corrupted some times...

Answer 1

[Sutanu Maiti]

You may use the status port value of the Serial Receive block of Android. Use data only if status is 1.

[Alireza Ghaderi]

I did this but still sometimes the transmission stops working... I think there should be a way to check start or end of the packet and start stroing from there...

Do you have an example in which a packet with multi data being set over serial to/from arrduino?