How to calculate IIR coefficient from filterDesigner
21 ビュー (過去 30 日間)
古いコメントを表示
Hi i am newbie and i am using filterDesiner command to generate an IIR filter. After finishing design filter with Filter Designer window, my result is as below:

And i generated a header C code file and my result is as below:

And i do not know how to convert my result to the coefficient i need. My coefficient i need is the coefficient in the equatation:
y(n) = b0*x(n) + b1*x(n-1) ... + bM*x(n-M) - a1*y(n-1) - ... - aN*y(n-M)
I need a table of [b0 .... bM] and [a1 ... aM].
0 件のコメント
回答 (2 件)
Sriram Tadavarty
2020 年 3 月 23 日
Hi Thanah,
To export the filiter coefficients, you can try the following as suggested here https://www.mathworks.com/help/signal/examples/introduction-to-filter-designer.html#FDAToolExample-8
Hope this helps.
Regards,
Sriram
2 件のコメント
Sriram Tadavarty
2020 年 3 月 24 日
編集済み: Sriram Tadavarty
2020 年 3 月 24 日
Hi,
You are right. For the IIR filter, the coefficients you get is in the form of SOS and G. To convert those in to filter numerator and denominator, you can try sos2tf function, which provides the required coefficients.
Hope this helps.
Regards,
Sriram
James Pollard
2021 年 11 月 10 日
Hi Thanh,
If you haven't already solved this problem by now, please see attached an Arduino library I wrote, which takes the outputted 'fdacoefs.h' file and realises it into an IIR filter.
If you study the fdacoefs.h file, you will notice that the 'num' array holds the B matrix coefficients and, likewise, the 'den' array holds both the A and S matrix coefficients.
If you realise this into simulink, you will find a block model of how these values are used. If this doesn't fit your equation model, then you should be able to adapt it.
0 件のコメント
参考
カテゴリ
Help Center および File Exchange で Filter Analysis についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!