How to generate WIFI signal source in MATLAB Simulink

I am trying to acheive the following , In a platform there will be multiple WIFI access points will be present and the devices available in the platform will be operating based on the WIFI generated from the access points. The main motive of this project is to track the strength of the WIFI signal used by different devices and also to check whether there is any interference in the signal when multiple devices access the WIFI. I am trying to acheive this using MATLAB simulink.

Answer 1

[Tejaswi Peesapati]

The following documentation illustrates the use of WLAN Toolbox to capture and process WI-FI signals.

https://www.mathworks.com/help/wlan/examples/802-11-ofdm-beacon-receiver-with-live-data.html

Additionally, the Signal Reception Examples documented below might give you a good idea about signal recovery and packet error rate simulation

https://www.mathworks.com/help/wlan/examples.html?category=signal-reception&s_tid=CRUX_lftnav_example_index

You may refer to the above examples to get started.

Hope this helps!!