How to model tapped windings in Simscape?

Hello,

I want to model a multi output flyback transformer with tapped at secondary windings. Therefore there will be two output of the transformer according to number of turns above and below the tap.

So far I have used a model as attached and also I a attached the configuration i want in reality.

I would like to know do the model and the reality match each other?

Any help will be highly appreciated.

Thanks

Answer 1

[Nikhil Sonavane]

You can refer to the documentation of Multi-Winding Transformer block which gives a detailed explanation about tapped transformer windings. You can adjust the number of of this block by double clicking on it adjusting the number of taps as required. You can also refer to the screenshot which I have attached.

[Gökhan Bayraktar]

Thanks for answer but I am using the simscape physical model blocks. So I can't use this.

[Nikhil Sonavane]

It would be great if you could share your Simscape model.

[Gökhan Bayraktar]

Here is my model and it seems close but i did not include the leakeage inductace on purpose.

Answer 2

[Adithya C]

You can use Mutual Inductor block in the MATLAB physical model system.