Change value of Simulink parameter inside of test harness to test two different variant subsystems
3 ビュー (過去 30 日間)
古いコメントを表示
Hello,
I need help to adapt simulink parameter EST_REF_VEL_RBT_MODE_CFG in test harness, so that I can test inside test harness (different ones are also possible) the variants shown below:
I am not able to change the value of the Simulink parameter since I get error
Constant or Parameter data EST_REF_VEL_RBT_MODE_CFG on left hand side of an expression.
as shown below:
How is it possible to adapt the given parameter value inside of test harness?
Thanks in advance.
Regards,
Samir Revelo
0 件のコメント
回答 (1 件)
Fangjun Jiang
2019 年 10 月 25 日
Just change the value of EST_REF_VEL_RBT_MODE_CFG. When its value is 1, ERVRBTModeHandling is activated. When the value is not 1, ERVNoRBTMode is activated. That is how Variant Subsystem works.
2 件のコメント
Mahantesh
2023 年 2 月 20 日
@Samir Revelo Even I am facing same error, Kindly let me know if you have solved this or any alternative solutions which you might have tried.
Thanks in advance.
参考
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!