SimEvents Parameter Sweep Signal Editor
1 回表示 (過去 30 日間)
古いコメントを表示
Hi all,
Currently, I'm working on a SimEvents model in Simulink.
For verification purposes I would like to perform a parameter sweep on the various settings available in this model.
I've managed to get this done for block parameters, however, the model also contains a Signal Editor for which I'm not able to set the signal within the sweep.
I expect the problem to be the timeseries necessary for the Signal Editor, not being a fixed value.
The Signal Editor must control an Entity Gate to open/close at times determined during the simulation.
In case you know a solution or a workaround, for example changing the Signal Editor for another actuation block, please let me know.
Kind regards,
Colin
0 件のコメント
回答 (1 件)
Zenin Easa Panthakkalakath
2019 年 10 月 16 日
Hello Colin,
I understand that the requirement is to be able to enable/disable Entity Gate based on a signal created using Signal Editor.
One way of doing this is to use Message Send block. This block creates an entity whenever the input signal supplied to the Port_Enable it is greater than zero. The output from this block can be connected to the Entity Gate control and the desired results can be achieved.
Regards,
Zenin
0 件のコメント
参考
カテゴリ
Help Center および File Exchange で Discrete-Event Simulation についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!