Thermocouple measurement in Simulink Desktop Real-time using National Instrument devices
1 回表示 (過去 30 日間)
古いコメントを表示
Hi,
I want to measure temperature using thermocouple . Currently I have NI-9211 module with chasis NI-cDaq-9174 using these I can get temperture in session based interface. Can I use these hardwares in Simulink Desktop real-time to get temperature and perform real time simulation? If not, then which NI device will be needed to take temperature reading using thermocouple.
Thanks a lot.
0 件のコメント
採用された回答
Roshni Garnayak
2019 年 8 月 22 日
Simulink supports NI 9211 and NI cDAQ-9174 for versions R2016b and above.
To get a list of National Instruments hardware supported by MATLAB and Simulink, refer to the following link:
2 件のコメント
Danny
2024 年 2 月 23 日
That is correct regarding Real time Sync block, did you manage to select K type thermocouple in the Simulink Anolog Input block in Data Acquisition Toolbox Library? I can only find mV measurement on my NI9212.
その他の回答 (0 件)
参考
カテゴリ
Help Center および File Exchange で Real-Time Simulation についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!