code generation failure using idelink_ert.tlc file

Hello,I am encountering a big problem duiring auto code generation on the TI F28335 hardware board.

After I configured the model using the idelink_ert.tlc instead of ert.tlc, I triger the "build model"，but an error occured as the following:

The call to idelink_ert_make_rtw_hook, during the entry hook generated the following error:

The model is configured to use a hardware board that has changed significantly since the release of MATLAB in which it was originally saved. Open the Upgrade Advisor and run the check "Check and update embedded target model to use ert.tlc system target file" to upgrade the model to the supported workflow.

How can I solve this problem and finish auto code generation?Thank you very much.

Answer 1

[Minglin Guo]

I turned to Matlab2018b which supports using grt.tlc instead of idelink_ert.tlc.