Using a bus-signal as an Input into a 'Model'-Block in Simulink
8 ビュー (過去 30 日間)
古いコメントを表示
Hello everybody,
I am currently working on quite a complex simulink-model. To make the model more modular I wanted to use the 'Model'-Block to allow an easy swap between pre-defined models. However since the model is very complex I am currently using bus-signals(virtual) to make the model more "readable" and it seems, that those signals do not get recognized by the 'model'-block and its contents. The error-message I receive is, that the signal in the 'Model'-Block is not a bus-signal, althought the signal I input is.
How do I get around this issue? I want to the modularity of the 'model'-block with the usability of the bus-signals. Are there alternitives? If not, then what does the bus-signal turn into, once it 'crosses' over to the 'model'-block?
Thank you in advance for your answers!
0 件のコメント
採用された回答
Fangjun Jiang
2019 年 7 月 30 日
see the demo model: sldemo_mdlref_conversion
2 件のコメント
Fangjun Jiang
2019 年 8 月 2 日
The error must be caused by something else. It sounds like a mismatch issue. It is expecting "Bus1.Bus2" but 'mysignal' is feeded, or vise versa.
You can certainly select any signal or bus element (no matter how "deep") within a bus using a BusSelector block. In the demo model (after the conversion), try to add LIMITBUS.lower_limit at the first BusSelector block inside the reference model.
その他の回答 (0 件)
参考
カテゴリ
Help Center および File Exchange で Simulink Environment Customization についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!