Empty thermal liquid tank

6 ビュー (過去 30 日間)
Sadeer Al-Rawashdeh
Sadeer Al-Rawashdeh 2019 年 7 月 11 日
how to have an empty thermal liquid tank with a volume of 0.357 m3 and a radius of 37 cm??
Thank you

回答 (1 件)

Sebastian Castro
Sebastian Castro 2019 年 7 月 11 日
Have you looked into Simscape Fluids? They have a built in Thermal Liquid tank block you can parameterize based on specs like the ones you mentioned.
https://www.mathworks.com/help/physmod/hydro/ref/tanktl.html
The only work you may need to do is convert the radius to a cross-sectional area parameter (Area = pi*R^2).
- Sebastian
  3 件のコメント
Sebastian Castro
Sebastian Castro 2019 年 7 月 11 日
And did you set the initial conditions in the Variables tab to start the tank empty? Because the default values are non-empty so that makes sense unless you change it.
Sadeer Al-Rawashdeh
Sadeer Al-Rawashdeh 2019 年 7 月 12 日
Yess but if you do so, you'll end up and error about the tank level that it is lower than the inlet height ! how can i fix that?

サインインしてコメントする。

カテゴリ

Help Center および File ExchangeElements についてさらに検索

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by