how to control dc motor by matlab gui with adafruit motorshield V1?

6 ビュー (過去 30 日間)
Bhavya Kishor Gatya
Bhavya Kishor Gatya 2019 年 4 月 6 日
コメント済み: Madhu Govindarajan 2019 年 8 月 12 日
please help to control dc motor by matlab gui with arduino adafruit shield V1

サインインしてこの質問に回答する。

回答 (1 件)

Tony Lennon
Tony Lennon 2019 年 8 月 9 日
Please take a look at this video. https://www.mathworks.com/videos/using-matlab-and-arduino-for-motor-control-100737.html
It's not exactly the same HW setup, but close.
  2 件のコメント
amin ya
amin ya 2019 年 8 月 10 日
This does not work! Motor Shield V1 requires legacy Matlab's Arduino support package and can't be installed beside new Matlab's Arduino support package.
Madhu Govindarajan
Madhu Govindarajan 2019 年 8 月 12 日
Adafruit Motor Shield V1 has been discontinued for a while and hence was never supported by the official MATLAB Support package. However, if you are interested here are a set of instructions that shows how to create your own custom support along with an example at the bottom of that page - https://www.mathworks.com/help/supportpkg/arduinoio/ug/custom-arduino-add-on-device-library-and-code.html
If you end up creating an add-on, please share with community using File Exchange.
Regards,
Madhu

サインインしてコメントする。

コミュニティ

カテゴリ

Help Center および File Exchange で Arduino Hardware についてさらに検索

タグ

製品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by