MATLAB Answers

"Selection for Simulink" Widget in IBM Doors NG

4 ビュー (過去 30 日間)
allofdogs 2019 年 1 月 31 日
コメント済み: Paul Urban 2020 年 6 月 17 日
I am trying to establish bidirection link using Simulink Requirements between a Simulink model and the requirement artifact in Doors NG. One I added the "Selection for Simulink" Widget, there is a link that is supposed to direct to the Simulink model but never works. I wonder if there is anything to do for setup.
I also consult with IBM and they said this widget was developed by Mathworks.
Thank you very much

  0 件のコメント


回答 (1 件)

Paul Urban
Paul Urban 2019 年 4 月 23 日
To set up the integration wtih DOORS Next Generation follow these steps described in the help:
This is a one time setup. Remember to run MATLAB as administrator when doing the rmi setup.

  3 件のコメント

MD Nawaz
MD Nawaz 2019 年 5 月 23 日
But i was unable to perform steps i.e. configure RMI Configure RMI for IBM Rational DOORS Next Generation Interaction in document
and even i couldnt find the folder "slrequirements" in my matlab installation folder (eventually to get dngllink folder) for Install the Simulink Requirements Widget in IBM Rational DOORS Next Generation.
please provide insights for above queries
Thanks in advance,
steve steve
steve steve 2020 年 6 月 17 日
slrequirements is part of the Requirements Toolbox install
Paul Urban
Paul Urban 2020 年 6 月 17 日
That is correct that Simulink Requirements needs to be installed. If it is then you may want to contact support for assistance on the installation with DNG


Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by