Failed to connect to the target f28069M in matlab simulink.

hi everyone,

ı want to use f28037 external mode but simulink gives below error.

matlab version 2017b, ccs v7 is used. out file of simulink works at ccs but external mode gives error.

error is ;

Error occurred while executing External Mode MEX-file 'ext_comm': Failed to connect to the targetFailed to connect to the target. A time-out occurred while waiting for the connection response from the target. Possible reasons for the time-out:

a) The target is not switched on.

b) The target is not connected to your host machine.

c) The application for the model is not running on the target. You might have clicked the Stop button. If the Run button is not dimmed, click it. Otherwise, click the Build button, which downloads and runs your application on the target.

how to solve this error??????

(before this usb port not recognized by device manager after I solved that problem by using following steps

At control panel-> device manager->Texas instrument probes

I select each of item click at properties, go to advance tab and marked load VCP checkbox.)

Answer 1

[Venkatesh Chilapur]

Please verify the MUX settings on the board and GPIO values in hardware configuation in Simulink.

You need have UART enabled on GPIO29 and 28. That is option 2 from table and the jumper settings for JP6 and JP7.

And the same GPIO needs to selected under SCI_A pane in simulink.

[dhanushka thennakoon]

thank you Venkatesh Chilapur

I removed the jumper of JP7 as you shown in figure.then i run, but same error shows.can you tell me how UART enable or disable of f28069M microcontroller.

thank you.

[Venkatesh Chilapur]

Here are my jumper settings..

[dhanushka thennakoon]

this is my jumper settings.I removed JP7 jumper after your advice.but it is not working.same error displaying

[Venkatesh Chilapur]

Hi dhanushka thennakoon,

JP6 is CH_SEL so remove the Jumper - In my picture it is mentioned as open.

JP7 is MUX_SEL so keep the Jumper - In my picture it is mentioned as closed.

Regards,

Venkatesh C

[dhanushka thennakoon]

Hi Venkatesh Chilapur

wow its work..

thank you sooo much..I didnt see full image of yours.Now I set the all the jumpers as you said.it properly works.thank you very much your corporation.

best regards,

Dhanushka

Answer 2

[Mehmet AKAR]

Hello Venkatesh chilapur, I have Drv8301 hc c2 kit with 28069 card. I am trying to control pmsm at sensorless mode. Firstly i used ti universal gui and motor was operated correctly. Then i tried to operate with simulink but i can't. I used simulink 28069 dual examples. Model was build succesfuly but motor doesnt start. Can you help about this subject. Is there any example with Drv8301 hc c2 kit? Kindest regards Dr Mehmet Akar

[Venkatesh Chilapur]

Hi Mehmet,

Please contact our support channel.

https://www.mathworks.com/support/contact_us.html

Regards,

Venkatesh C

Answer 3

[Haris Ç]

Dear Venkatesh Chilapur,

I have a LaunchpadXL TMS320F28069M card. I am trying to use external mode in Simulink. I removed the JP6 and keep the rest jumpers as illustrated in your figure. However, I could not manage to run my simulink correctly. Maybe, I could not entirely configurate the hardware (baudrate, SCI_A etc.).

Could you please share a simulink file which is organized for the external mode operation?

Best regards,

Dr. Haris C.