Simulink model for DC shunt motor does not give correct output despite no errors.

2 ビュー (過去 30 日間)
Saiankita Anand
Saiankita Anand 2018 年 10 月 14 日
回答済み: Sabin 2024 年 12 月 24 日
The attached Simulink .mdl file (MATLAB 2017) contains a model for DC shunt motor. The DC motor block was cut and pasted from MATLAB 2014. The model runs but the output is not correct. Scope does not show plots for armature current vs speed, torque vs speed.
Help and suggestions appreciated.

サインインしてこの質問に回答する。

回答 (1 件)

Sabin
Sabin 2024 年 12 月 24 日
This seems to be a parameterization issue. Increasing the field resistance to 150 Ohm will enable simulation to a nonzero speed. The exact parameterization will depend on application requirements.

コミュニティ

カテゴリ

Help Center および File Exchange で Motor Drives についてさらに検索

タグ

製品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by